參數資料
型號： CY3687
廠商： Cypress Semiconductor Corp.
英文描述： MoBL-USB⑩ FX2LP18 USB Microcontroller
中文描述： 的MoBL - USB FX2LP18的USB微控制器⑩
文件頁數： 39/39頁
文件大?。?/td> 453K
代理商： CY3687
Document # 001-06120 Rev *H
Revised August 6, 2007
Page 39 of 39
Purchase of I2C components from Cypress, or one of its sublicensed Associated Companies, conveys a license under the Philips I2C Patent Rights to use these components in an I2C system, provided
that the system conforms to the I2C Standard Specification as defined by Philips. MoBL-USB FX2LP18, EZ-USB FX2LP and ReNumeration are trademarks, and MoBL-USB is a registered trademark,
of Cypress Semiconductor Corporation. All product and company names mentioned in this document are the trademarks of their respective holders.
CY7C68053
Cypress Semiconductor Corporation, 2007. The information contained herein is subject to change without notice. Cypress Semiconductor Corporation assumes no responsibility for the use of any
circuitry other than circuitry embodied in a Cypress product. Nor does it convey or imply any license under patent or other rights. Cypress products are not warranted nor intended to be used for medical,
life support, life saving, critical control or safety applications, unless pursuant to an express written agreement with Cypress. Furthermore, Cypress does not authorize its products for use as critical
components in life-support systems where a malfunction or failure may reasonably be expected to result in significant injury to the user. The inclusion of Cypress products in life-support systems
application implies that the manufacturer assumes all risk of such use and in doing so indemnifies Cypress against all charges.
Any Source Code (software and/or firmware) is owned by Cypress Semiconductor Corporation (Cypress) and is protected by and subject to worldwide patent protection (United States and foreign),
United States copyright laws and international treaty provisions. Cypress hereby grants to licensee a personal, non-exclusive, non-transferable license to copy, use, modify, create derivative works of,
and compile the Cypress Source Code and derivative works for the sole purpose of creating custom software and or firmware in support of licensee product to be used only in conjunction with a Cypress
integrated circuit as specified in the applicable agreement. Any reproduction, modification, translation, compilation, or representation of this Source Code except as specified above is prohibited without
the express written permission of Cypress.
Disclaimer: CYPRESS MAKES NO WARRANTY OF ANY KIND, EXPRESS OR IMPLIED, WITH REGARD TO THIS MATERIAL, INCLUDING, BUT NOT LIMITED TO, THE IMPLIED WARRANTIES
OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. Cypress reserves the right to make changes without further notice to the materials described herein. Cypress does not
assume any liability arising out of the application or use of any product or circuit described herein. Cypress does not authorize its products for use as critical components in life-support systems where
a malfunction or failure may reasonably be expected to result in significant injury to the user. The inclusion of Cypress’ product in a life-support systems application implies that the manufacturer
assumes all risk of such use and in doing so indemnifies Cypress against all charges.
Use may be limited by and subject to the applicable Cypress software license agreement.
Document History Page
Document Title: CY7C68053 MoBL-USB FX2LP18 USB Microcontroller
Document Number: 001-06120
Orig. of
Change
**
430449
03/03/06
*A
434754
03/24/06
REV.
ECN NO.
Issue Date
Description of Change
OSG
OSG
New data sheet
In Section 3.3, stated that SCL and SDA pins can be connected to V
CC
or V
CC_IO
Changed sections 3.5, 3.18.1 and pin descriptions of SCL, SDA to indicate that
since DISCON=1 after reset, an EEPROM or EEPROM emulation is required on
the I
2
C interface
In pin description table, renamed pin 2H (Reserved) to Ground
In Section 6, added statement “The GPIO’s are not over voltage tolerant, except the
SCL and SDA pins, which are 3.3V tolerant“
In Section 8,added a footnote to the DC char table stating that AVcc can be floated
in low power mode
In Section 8, changed V
IH
max in DC char table from 3.6V to V
CC_IO
+ 10%
Changed the recommendation for the pull up resistors on I
2
C
Split Icc into 4 different values, corresponding to the different voltage supplies
Changed Isus typical to 20uA and 220uA
Added section 3.9.3 on suspend current considerations
Removed all references the part number CY7C68055. Corrected the bullet in
Features to state that 24 GPIO’s are available. Added the Test ID (TID#) to the
Features on the front page. Made changes to the block diagram on the first page
(this is now a Visio drawing instead of a Framemaker drawing). Corrected the
Ambient Temperature with Power Supplied. Moved figure titles to meet the new
template. Checked grammar. Took out 9-bit address bus from the block diagram on
the first page. Corrected Figure 4.1
Added Icc data in DC Characteristics and Maximum Power dissipation
Changed ESD spec to 1500V
Changed ESD spec to 2000V and 1500V only for SCL and SDA pins.
Added min spec for t
OEoff
Changed Icc and power dissipation numbers
Removed SLCS from figure in Section 9.6 Slave FIFO Asynchronous Write
Changed SLWR Pulse HIGH parameter to 50ns
Section 9.13.1 - Removed the indication that SLCS and SLRD can be asserted
together
Section 9.13.3 - Removed the indication that SLCS and SLRD can be asserted
together
Implemented the latest template.
Section 7 - Changed -0°C to -40°C
*B
465471
See ECN
OSG
*C
484726
See ECN
ARI
*D
*E
*F
492009
500408
502115
See ECN
See ECN
See ECN
OSG
OSG
OSG
*G
1128404
See ECN
OSG/ARI
*H
1349903
See ECN
AESA
[+] Feedback
相關PDF資料
PDF描述
CY37128VP160-100BAXC 5V, 3.3V, ISRTM High-Performance CPLDs
CY37032P44-125AC 5V, 3.3V, ISRTM High-Performance CPLDs
CY37064P44-200AC 5V, 3.3V, ISR⑩ High-Performance CPLDs
CY37064P44-200JC 5V, 3.3V, ISR⑩ High-Performance CPLDs
CY37384VP100-200JXC 5V, 3.3V, ISRTM High-Performance CPLDs
相關代理商/技術參數
參數描述
CY3688 功能描述:界面開發工具 CY3688 RoHS:否 制造商:Bourns 產品:Evaluation Boards 類型:RS-485 工具用于評估:ADM3485E 接口類型:RS-485 工作電源電壓:3.3 V
CY3690 功能描述:開發板和工具包 - 其他處理器 USB 2.0 DVEL KIT RoHS:否 制造商:Freescale Semiconductor 產品:Development Systems 工具用于評估:P3041 核心:e500mc 接口類型:I2C, SPI, USB 工作電源電壓:
CY3691 功能描述:開發板和工具包 - 其他處理器 USB 2.0 DVEL KIT RoHS:否 制造商:Freescale Semiconductor 產品:Development Systems 工具用于評估:P3041 核心:e500mc 接口類型:I2C, SPI, USB 工作電源電壓:
CY3692 功能描述:時鐘和定時器開發工具 Socket adapter "for CY23FP12" RoHS:否 制造商:Texas Instruments 產品:Evaluation Modules 類型:Clock Conditioners 工具用于評估:LMK04100B 頻率:122.8 MHz 工作電源電壓:3.3 V
CY3693 制造商:CYPRESS 制造商全稱:Cypress Semiconductor 功能描述:PTG Programming Kit
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*