- 您現在的位置：買賣IC網 > PDF目錄298828 > APTH020A0X3-SRZ (LINEAGE POWER LLC) 1-OUTPUT DC-DC REG PWR SUPPLY MODULE PDF資料下載
參數資料
| 型號： | APTH020A0X3-SRZ |
| 廠商： | LINEAGE POWER LLC |
| 元件分類： | 電源模塊 |
| 英文描述： | 1-OUTPUT DC-DC REG PWR SUPPLY MODULE |
| 封裝： | ROHS COMPLIANT PACKAGE-10/8 |
| 文件頁數： | 5/23頁 |
| 文件大?。?/td> | 556K |
| 代理商： | APTH020A0X3-SRZ |
Data Sheet
April 7, 2011
TLynxTM: Non-isolated DC-DC Power Modules:
2.4 – 5.5Vdc input; 0.6Vdc to 3.63Vdc output; 20A output current
LINEAGE POWER
13
Feature Descriptions
Remote On/Off
The TLynx
TM modules feature an On/Off pin for remote
On/Off operation. Two On/Off logic options are
available. In the Positive Logic On/Off option, (device
code suffix “4”- see Ordering Information), the module
turns ON during a logic High on the On/Off pin and turns
OFF during a logic Low. With the Negative Logic
On/Off option, (no device code suffix, see Ordering
Information), the module turns OFF during logic High
and ON during logic Low. The On/Off signal is always
referenced to ground. For either On/Off logic option,
leaving the On/Off pin disconnected will turn the module
ON when input voltage is present.
For positive logic modules, the circuit configuration for
using the On/Off pin is shown in Figure 38. When the
external transistor Q1 is in the OFF state, the On/Off pin
is pulled high internally and the module is ON. When
transistor Q1 is turned ON, the On/Off pin is pulled low
and the module is OFF.
6.34K
Q1
GND
ON/OFF
VIN+
_
+
PWM Enable
I
VON/OFF
MODULE
ON/OFF
Q2
20K
470
Figure 38. Circuit configuration for using positive
On/Off logic.
For negative logic On/Off modules, the circuit
configuration is shown in Fig. 39. The On/Off pin should
be pulled high with an external pull-up resistor
(suggested value for the 2.4V to 5.5Vin range is
8.2Kohms). When transistor Q1 is in the OFF state, the
On/Off pin is pulled high and the module is OFF. The
On/Off threshold for logic High on the On/Off pin
depends on the input voltage and its minimum value is
VIN – 1.6V. To turn the module ON, Q1 is turned ON
pulling the On/Off pin low.
Overcurrent Protection
To provide protection in a fault (output overload)
condition, the unit is equipped with internal
current-limiting circuitry and can endure current limiting
continuously. At the point of current-limit inception, the
unit enters hiccup mode. The unit operates normally
once the output current is brought back into its specified
range.
6.34K
Q1
GND
PWM Enable
ON/OFF
VIN+
ON/OFF
_
+
I
V
MODULE
Rpullup
470
ON/OFF
3.09K
PTC
Figure 39. Circuit configuration for using negative
On/Off logic.
Overcurrent Protection
To provide protection in a fault condition, the unit is
equipped with a thermal shutdown circuit. The unit will
shutdown if the overtemperature threshold of 144
oC is
exceeded at the thermal reference point Tref . The
thermal shutdown is not intended as a guarantee that
the unit will survive temperatures beyond its rating.
Once the unit goes into thermal shutdown it will then
wait to cool before attempting to restart.
Input Undervoltage Lockout
At input voltages below the input undervoltage lockout
limit, the module operation is disabled. The module will
begin to operate at an input voltage above the
undervoltage lockout turn-on threshold.
Output Voltage Programming
The output voltage of the TLynx
TM module can be
programmed to any voltage from 0.6dc to 3.63Vdc by
connecting a resistor between the Trim+ and GND pins
of the module. Certain restrictions apply on the output
voltage set point depending on the input voltage. These
are shown in the Output Voltage vs. Input Voltage Set
Point Area plot in Fig. 40. The Upper Limit curve shows
that the entire output voltage range is available with the
maximum input voltage of 5.5V. The Lower Limit curve
shows that for output voltages of 1.8V and higher, the
input voltage needs to be larger than the minimum of
2.4V.
相關PDF資料 |
PDF描述 |
|---|---|
| APV1122AZ | SPECIALTY OPTOELECTRONIC DEVICE |
| APX810-44SR-G-7 | 1-CHANNEL POWER SUPPLY SUPPORT CKT, PDSO3 |
| APXS006A0X-SRDZ | 1-OUTPUT 33 W DC-DC REG PWR SUPPLY MODULE |
| AQ3A2-J-ZT4/32VDC | TRIGGER OUTPUT SOLID STATE RELAY, 4000 V ISOLATION-MAX |
| AQC1A1-T24VDC-R | TRIGGER OUTPUT SOLID STATE RELAY, 2500 V ISOLATION-MAX |
相關代理商/技術參數 |
參數描述 |
|---|---|
| APTH020A0X43-SRZ | 功能描述:DC/DC轉換器 2.4-5.5Vin Pos logic 0.6-3.63Vout 20A SMT RoHS:否 制造商:Murata 產品: 輸出功率: 輸入電壓范圍:3.6 V to 5.5 V 輸入電壓（標稱）: 輸出端數量:1 輸出電壓（通道 1）:3.3 V 輸出電流（通道 1）:600 mA 輸出電壓（通道 2）: 輸出電流（通道 2）: 安裝風格:SMD/SMT 封裝 / 箱體尺寸: |
| APTJC120AM13VCT1AG | 功能描述:MOSFET SIC PHASE LEG MODULE RoHS:是 類別:半導體模塊 >> FET 系列:- 標準包裝:10 系列:* |
| APTJC120AM25VCT1AG | 功能描述:MOSFET MODULE RoHS:是 類別:半導體模塊 >> FET 系列:- 標準包裝:10 系列:* |
| APTK2012CGCK-F01 | 功能描述:標準LED-SMD Green 570nm Water Clear 60mcd RoHS:否 制造商:Vishay Semiconductors 封裝 / 箱體:0402 LED 大小:1 mm x 0.5 mm x 0.35 mm 照明顏色:Red 波長/色溫:631 nm 透鏡顏色/類型:Water Clear 正向電流:30 mA 正向電壓:2 V 光強度:54 mcd 顯示角:130 deg 系列:VLMx1500 封裝:Reel |
| APTK2012MBC | 制造商:Kingbright Corporation 功能描述:LED Uni-Color Blue 430nm 2-Pin Chip LED T/R |
發布緊急采購，3分鐘左右您將得到回復。