- 您現在的位置：買賣IC網 > PDF目錄3872 > PIC24FJ16GA002-I/SS (Microchip Technology)IC PIC MCU FLASH 16K 28-SSOP PDF資料下載
參數資料
| 型號： | PIC24FJ16GA002-I/SS |
| 廠商： | Microchip Technology |
| 文件頁數： | 28/52頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC PIC MCU FLASH 16K 28-SSOP |
| 產品培訓模塊： | Graphics LCD System and PIC24 Interface Asynchronous Stimulus |
| 特色產品： | PIC24FJ/33FJ MCUs & dsPIC? DSCs |
| 標準包裝： | 47 |
| 系列： | PIC® 24F |
| 核心處理器： | PIC |
| 芯體尺寸： | 16-位 |
| 速度： | 32MHz |
| 連通性： | I²C，PMP，SPI，UART/USART |
| 外圍設備： | 欠壓檢測/復位，LVD，POR，PWM，WDT |
| 輸入/輸出數： | 21 |
| 程序存儲器容量： | 16KB（5.5K x 24） |
| 程序存儲器類型： | 閃存 |
| RAM 容量： | 4K x 8 |
| 電壓 - 電源 (Vcc/Vdd)： | 2 V ~ 3.6 V |
| 數據轉換器： | A/D 10x10b |
| 振蕩器型： | 內部 |
| 工作溫度： | -40°C ~ 85°C |
| 封裝/外殼： | 28-SSOP（0.209"，5.30mm 寬） |
| 包裝： | 管件 |
| 產品目錄頁面： | 647 (CN2011-ZH PDF) |
| 配用： | DM240011-ND - KIT STARTER MPLAB FOR PIC24F MCU AC162088-ND - HEADER MPLAB ICD2 24FJ64GA004 28 AC164338-ND - MOD SKT PIC24F/DSPIC33F 28SOIC DV164033-ND - KIT START EXPLORER 16 MPLAB ICD2 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁當前第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁
PIC24FJXXXGA0XX
DS39768D-page 34
2008 Microchip Technology Inc.
5.0
THE PROGRAMMING
EXECUTIVE
5.1
Programming Executive
Communication
The programmer and programming executive have a
master-slave relationship, where the programmer is
the master programming device and the programming
executive is the slave.
All communication is initiated by the programmer in the
form of a command. Only one command at a time can
be sent to the programming executive. In turn, the
programming executive only sends one response to
the programmer after receiving and processing a
command. The programming executive command set
is described in Section 5.2 “Programming Executive
Commands”. The response set is described in
5.1.1
COMMUNICATION INTERFACE
AND PROTOCOL
The Enhanced ICSP interface is a 2-wire SPI,
implemented using the PGCx and PGDx pins. The
PGCx pin is used as a clock input pin and the clock
source must be provided by the programmer. The
PGDx pin is used for sending command data to, and
receiving response data from, the programming
executive.
Data transmits to the device must change on the rising
edge and hold on the falling edge. Data receives from
the device must change on the falling edge and hold on
the rising edge.
All data transmissions are sent to the Most Significant
bit (MSb) first, using 16-bit mode (see Figure 5-1).
FIGURE 5-1:
PROGRAMMING
EXECUTIVE SERIAL
TIMING FOR DATA
RECEIVED FROM DEVICE
FIGURE 5-2:
PROGRAMMING
EXECUTIVE SERIAL TIMING
FOR DATA TRANSMITTED
TO DEVICE
Since a 2-wire SPI is used, and data transmissions are
half duplex, a simple protocol is used to control the
direction of PGDx. When the programmer completes a
command transmission, it releases the PGDx line and
allows the programming executive to drive this line
high. The programming executive keeps the PGDx line
high to indicate that it is processing the command.
After the programming executive has processed the
command, it brings PGDx low for 15
μsec to indicate to
clocked out. The programmer can begin to clock out the
response 23
μsec after PGDx is brought low, and it must
provide the necessary amount of clock pulses to receive
the entire response from the programming executive.
After the entire response is clocked out, the program-
mer should terminate the clock on PGCx until it is time
to send another command to the programming
executive. This protocol is shown in Figure 5-3.
5.1.2
SPI RATE
In Enhanced ICSP mode, the PIC24FJXXXGA0XX
family devices operate from the internal Fast RC oscil-
lator (FRCDIV), which has a nominal frequency of
8 MHz. This oscillator frequency yields an effective
system clock frequency of 4 MHz. To ensure that the
programmer does not clock too fast, it is recommended
that a 4 MHz clock be provided by the programmer.
5.1.3
TIME-OUTS
The programming executive uses no Watchdog Timer
or time-out for transmitting responses to the program-
mer. If the programmer does not follow the flow control
mechanism using PGCx, as described in Section 5.1.1
possible that the programming executive will behave
unexpectedly while trying to send a response to the
programmer. Since the programming executive has no
time-out, it is imperative that the programmer correctly
follow the described communication protocol.
As a safety measure, the programmer should use the
command time-outs identified in Table 5-1. If the
command time-out expires, the programmer should
reset
the
programming
executive
and
start
programming the device again.
PGCx
PGDx
12
3
11
13
15
16
14
12
LSb
14
13
12
11
45
6
MSb
1
2
3
...
4
5
P2
P3
P1
P1B
P1A
PGCx
PGDx
12
3
11
13
15
16
14
12
LSb
14
13 12
11
45
6
MSb
1
2
3
...
4
5
P2
P3
P1
P1B
P1A
相關PDF資料 |
PDF描述 |
|---|---|
| PIC16C55A-04I/SO | IC MCU OTP 512X12 28SOIC |
| PIC16CR77-I/ML | IC PIC MCU 8KX14 44QFN |
| PIC16CR74T-I/PT | IC PIC MCU 4KX14 44TQFP |
| PIC16F627A-I/ML | IC MCU FLASH 1KX14 EEPROM 28QFN |
| PIC24F08KL401-I/P | IC MCU 16BIT 8KB FLASH 20-PDIP |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ADA4896-2ARM-EBZ | 制造商:Analog Devices 功能描述:ADA4896-2 DUAL OP AMP EVAL BOARD 制造商:Analog Devices 功能描述:Bare evaluation board, ADA4896-2,MSOP8 |
| ADA4896-2ARMZ | 功能描述:IC OP AMP LOW NOISE 8-MSOP RoHS:是 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 標準包裝:1 系列:- 放大器類型:通用 電路數:4 輸出類型:滿擺幅 轉換速率:0.028 V/µs 增益帶寬積:105kHz -3db帶寬:- 電流 - 輸入偏壓:3nA 電壓 - 輸入偏移:100µV 電流 - 電源:3.3µA 電流 - 輸出 / 通道:12mA 電壓 - 電源，單路/雙路(±):2.7 V ~ 12 V，±1.35 V ~ 6 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:14-TSSOP（0.173"，4.40mm 寬） 供應商設備封裝:14-TSSOP 包裝:剪切帶 (CT) 其它名稱:OP481GRUZ-REELCT |
| ADA4896-2ARMZ_PROMO | 制造商:Analog Devices 功能描述:IC OP AMP R/R LOW POWER MS |
| ADA4896-2ARMZ-R7 | 功能描述:IC OPAMP GP R-R 50MHZ LP 8MSOP RoHS:是 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 標準包裝:73 系列:Over-The-Top® 放大器類型:通用 電路數:4 輸出類型:滿擺幅 轉換速率:0.07 V/µs 增益帶寬積:200kHz -3db帶寬:- 電流 - 輸入偏壓:1nA 電壓 - 輸入偏移:285µV 電流 - 電源:50µA 電流 - 輸出 / 通道:25mA 電壓 - 電源，單路/雙路(±):2 V ~ 44 V，±1 V ~ 22 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:16-WFDFN 裸露焊盤 供應商設備封裝:16-DFN-EP（5x3） 包裝:管件 |
| ADA4896-2ARMZ-RL | 制造商:AD 制造商全稱:Analog Devices 功能描述:1 nV/√Hz, Low Power |
發布緊急采購，3分鐘左右您將得到回復。