- 您現在的位置：買賣IC網 > PDF目錄375243 > AD8200YCHIPS (ANALOG DEVICES INC) High Common-Mode Voltage, Single-Supply Difference Amplifier PDF資料下載
參數資料
| 型號： | AD8200YCHIPS |
| 廠商： | ANALOG DEVICES INC |
| 元件分類： | 運動控制電子 |
| 英文描述： | High Common-Mode Voltage, Single-Supply Difference Amplifier |
| 中文描述： | OP-AMP, 1000 uV OFFSET-MAX, UUC7 |
| 封裝： | DIE-7 |
| 文件頁數： | 8/12頁 |
| 文件大?。?/td> | 231K |
| 代理商： | AD8200YCHIPS |
REV. B
–8–
AD8200
HIGH-LINE CURRENT SENSING WITH LPF AND GAIN
ADJUSTMENT
Figure 11 is another refinement of Figure 1, including gain
adjustment and low-pass filtering.
5V
OUTPUT
4V/AMP
INDUCTIVE
LOAD
POWER
DEVICE
4 TERM
SHUNT
CLAMP
DIODE
BATTERY
14V
COMMON
C
V
NULL
191k
20k
5% CALIBRATION RANGE
F
= 0.796Hz– F
(0.22 F FOR f = 3.6 Hz)
NC = NO CONNECT
GND
NC
–IN
+IN
A1
+V
S
A2
OUT
AD8200
Figure 11. High-Line Current Sensor Interface; Gain =
×
40,
Single-Pole, Low-Pass Filter
A power device that is either ON or OFF controls the current in
the load. The average current is proportional to the duty cycle of
the input pulse and is sensed by a small value resistor. The
average differential voltage across the shunt is typically 100mV,
although its peak value will be higher by an amount that depends
on the inductance of the load and the control frequency. The
common-mode voltage, on the other hand, extends from roughly
1 V above ground, when the switch is ON, to about 1.5 V
above the battery voltage, when the device is OFF, and the
clamp diode conducts. If the maximum battery voltage spikes
up to 20 V, the common-mode voltage at the input can be as
high as 21.5 V.
To produce a full-scale output of 4 V, a gain
×
40 is used, adjust-
able by
±
5% to absorb the tolerance in the shunt. There is
sufficient headroom to allow 10% overrange (to 4.4 V). The
roughly triangular voltage across the sense resistor is averaged
by a 1-pole, low-pass filter, here set with a corner frequency =
3.6 Hz, which provides about 30 dB of attenuation at 100 Hz. A
higher rate of attenuation can be obtained using a 2-pole filter
having f
C
= 20 Hz, as shown in Figure 12. Although this circuit
uses two separate capacitors, the total capacitance is less than
half that needed for the 1-pole filter.
5V
OUTPUT
INDUCTIVE
LOAD
POWER
DEVICE
4 TERM
SHUNT
CLAMP
DIODE
BATTERY
14V
COMMON
C
127k
432k
50k
F
= 1Hz– F
(0.05 F FOR f
C
= 20Hz)
C
NC = NO CONNECT
GND
NC
–IN
+IN
A1
+V
S
A2
OUT
AD8200
Figure 12. Illustration of 2-Pole Low-Pass Filtering
DRIVING CHARGE REDISTRIBUTION A/D
CONVERTERS
When driving CMOS ADCs, such as those embedded in
popular microcontrollers, the charge injection ( Q) can cause
a significant deflection in the output voltage of the AD8200.
Though generally of short duration, this deflection may persist
until after the sample period of the ADC has expired, due to the
relatively high open-loop output impedance of the AD8200.
Including an R-C network in the output can significantly reduce
the effect. The capacitor helps to absorb the transient charge,
effectively lowering the high frequency output impedance of the
AD8200. For these applications, the output signal should be
taken from the midpoint of the R
LAG
– C
LAG
combination as
shown in Figure 13.
Since the perturbations from the analog-to-digital converter are
small, the output impedance of the AD8200 will appear to be
low. The transient response will, therefore, have a time constant
governed by the product of the two LAG components, C
LAG
×
R
LAG
. For the values shown in Figure 13, this time constant is
programmed at approximately 10
μ
s. Therefore, if samples are
taken at several tens of microseconds or more, there will be
negligible charge “stack-up.”
+IN
–IN
10k
10k
AD8200
5V
R
LAG
1k
C
0.01 F
MICROPROCESSOR
A/D
A2
Figure 13. Recommended Circuit for Driving CMOS A/D
相關PDF資料 |
PDF描述 |
|---|---|
| AD8200YCSURF | High Common-Mode Voltage, Single-Supply Difference Amplifier |
| AD8206YCSURF | Single-Supply 42 V System Difference Amplifier |
| AD8206YR | Single-Supply 42 V System Difference Amplifier |
| AD8206YR-REEL | Single-Supply 42 V System Difference Amplifier |
| AD8206YR-REEL7 | Single-Supply 42 V System Difference Amplifier |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AD8200YCSURF | 制造商:Analog Devices 功能描述: |
| AD8200YR | 制造商:Analog Devices 功能描述:AMP DIFF SINGLE SUPPLY SMD 8200 |
| AD8200YR-REEL | 制造商:Analog Devices 功能描述:SP Amp Difference Amplifier Dual 12V 8-Pin SOIC N T/R |
| AD8200YR-REEL7 | 制造商:Analog Devices 功能描述:SP Amp Difference Amplifier Dual 12V 8-Pin SOIC N T/R |
| AD8200YR-REEL-7 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Amplifier. Other |
發布緊急采購，3分鐘左右您將得到回復。