- 您現在的位置：買賣IC網 > PDF目錄375240 > AD7874SE (ANALOG DEVICES INC) 10-Bit, 75 MSPS ADC SE/Diff, Int/Ext Ref., program. i/p range w/Pwrdown, comp. to ADS822/3/5/6 28-SSOP PDF資料下載
參數資料
| 型號： | AD7874SE |
| 廠商： | ANALOG DEVICES INC |
| 元件分類： | ADC |
| 英文描述： | 10-Bit, 75 MSPS ADC SE/Diff, Int/Ext Ref., program. i/p range w/Pwrdown, comp. to ADS822/3/5/6 28-SSOP |
| 中文描述： | 4-CH 12-BIT SUCCESSIVE APPROXIMATION ADC, PARALLEL ACCESS, CQCC28 |
| 封裝： | CERAMIC, LCC-28 |
| 文件頁數： | 10/16頁 |
| 文件大?。?/td> | 414K |
| 代理商： | AD7874SE |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁當前第10頁第11頁第12頁第13頁第14頁第15頁第16頁
AD7874
REV. C
–10–
MICROPROCE SSOR INT E RFACING
T he AD7874 high speed bus timing allows direct interfacing to
DSP processors as well as modern 16-bit microprocessors.
Suitable microprocessor interfaces are shown in Figures 12
through 16.
AD7874–ADSP-2100 Interface
Figure 12 shows an interface between the AD7874 and the
ADSP-2100. Conversion is initiated using a timer which allows
very accurate control of the sampling instant on all four chan-
nels. T he AD7874
INT
line provides an interrupt to the ADSP-
2100 when conversion is completed on all four channels. T he
four conversion results can then be read from the AD7874 using
four successive reads to the same memory address. T he follow-
ing instruction reads one of the four results (this instruction is
repeated four times to read all four results in sequence):
MR0 = DM(ADC)
where MR0 is the ADSP-2100 MR0 register and
ADC is the AD7874 address.
TIMER
DMA0
DMA13
DMD15
DMD0
DMS
EN
ADDR
DECODE
ADDRESS BUS
ADSP-2100
(ADSP-2101/
ADSP-2102)
* ADDITIONAL PINS OMITTED FOR CLARITY
DATA BUS
CONVST
CS
DB11
DB0
RD
INT
AD7874*
IRQn
DMRD (RD)
Figure 12. AD7874–ADSP-2100 Interface
AD7874–ADSP-2101/ADSP-2102 Interface
T he interface outlined in Figure 12 also forms the basis for an
interface between the AD7874 and the ADSP-2101/ADSP-2102.
T he READ line of the ADSP-2101/ADSP-2102 is labeled
RD
.
In this interface, the
RD
pulse width of the processor can be
programmed using the Data Memory Wait State Control Regis-
ter. T he instruction used to read one of the four results is as
outlined for the ADSP-2100.
AD7874–T MS32010 Interface
An interface between the AD7874 and the T MS32010 is shown
in Figure 13. Once again the conversion is initiated using an ex-
ternal timer and the T MS32010 is interrupted when all four
conversions have been completed. T he following instruction is
used to read the conversion results from the AD7874:
IN D,ADC
where D is Data Memory address and
ADC is the AD7874 address.
PA0
PA2
D15
D0
MEN
EN
ADDR
DECODE
ADDRESS BUS
TIMER
DATA BUS
CONVST
CS
DB11
DB0
RD
INT
AD7874*
TMS32010
*ADDITIONAL PINS OMITTED FOR CLARITY
INT
DEN
Figure 13. AD7874–TMS32010 Interface
AD7874–T MS320C25 Interface
Figure 14 shows an interface between the AD7874 and the
T MS320C25. As with the two previous interfaces, conversion is
initiated with a timer and the processor is interrupted when the
conversion sequence is completed. T he T MS320C25 does not
have a separate
RD
output to drive the AD7874
RD
input di-
rectly. T his has to be generated from the processor ST RB and
R/
W
outputs with the addition of some logic gates. T he
RD
sig-
nal is OR-gated with the MSC signal to provide the one WAIT
state required in the read cycle for correct interface timing.
Conversion results are read from the AD7874 using the follow-
ing instruction:
IN D,ADC
where D is Data Memory address and
ADC is the AD7874 address.
A0
A15
D15
D0
IS
EN
ADDR
DECODE
ADDRESS BUS
TIMER
DATA BUS
CONVST
CS
DB11
DB0
RD
INT
AD7874*
TMS320C25
*ADDITIONAL PINS OMITTED FOR CLARITY
INTn
R/W
STRB
MSC
READY
Figure 14. AD7874–TMS320C25 Interface
相關PDF資料 |
PDF描述 |
|---|---|
| AD7874SQ | LC2MOS 4-Channel, 12-Bit Simultaneous Sampling Data Acquisition System |
| AD7877ACPZ-REEL7 | 16-Bit, Pseudo Bipolar, Fully Diff Input, 250kSPS Serial Out, 2.7V to 5.5V Micro Power Sampling ADC 8-MSOP -40 to 85 |
| AD7877 | Touch Screen Controller |
| AD7877ACP-500RL7 | Touch Screen Controller |
| AD7877ACP-REEL | Touch Screen Controller |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AD7874SE/883B | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Single-Ended Data Acquisition System |
| AD7874SE3 | 制造商:AD 制造商全稱:Analog Devices 功能描述:LC2MOS 4-Channel, 12-Bit Simultaneous Sampling Data Acquisition System |
| AD7874SQ | 功能描述:IC DAS 12BIT 4CH 5V 28-CDIP RoHS:否 類別:集成電路 (IC) >> 數據采集 - ADCs/DAC - 專用型 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:50 系列:- 類型:數據采集系統（DAS） 分辨率（位）:16 b 采樣率（每秒）:21.94k 數據接口:MICROWIRE?，QSPI?，串行，SPI? 電壓電源:模擬和數字 電源電壓:1.8 V ~ 3.6 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:40-WFQFN 裸露焊盤 供應商設備封裝:40-TQFN-EP（6x6） 包裝:托盤 |
| AD7874SQ/883B | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Single-Ended Data Acquisition System |
| AD7874SQ3 | 制造商:AD 制造商全稱:Analog Devices 功能描述:LC2MOS 4-Channel, 12-Bit Simultaneous Sampling Data Acquisition System |
發布緊急采購，3分鐘左右您將得到回復。